H. Creation of the Ruler multifunctional

What do > Association Religious Clerical > Works of Apostolate > Do-It-Yourself Mask

Do-It-Yourself Mask

an economic way to achieve it

H. CREATION OF THE RULER MULTIFUNCTIONAL


Introduction and Clarifications		G.1- Assembly of the Mask - First Phase
A. Consumables		G.2- Assembly of the Mask - Second Phase
B. Equipment		G.3- Assembly of the Mask - Final Results
C. Working Table		H. Creacion of the Rule multifunctional
D. Squadring an Drilling of the "Structure"		I. Creacion of the Matrix for the "Structure" and the "Screen"
E. Squadring an Drilling of the "Screen"		J. Creation of the Matrix for the "Pillow"
F. Squadring an Drilling of the "Pillow"		K. Creacion of the Forms of work

H. CREATION OF THE RULER MULTIFUNCTIONAL

a. A particular row is created, with the intention of facilitating the identification of the points on the Master Forms, in view of their drilling: the multifunctional Ruler.

b. A cardboard of 13.5 cm of base for 2.5 cm of height is prepared: on the base four points are identified, in correspondence of which later holes will be drilled.

c. These points must be 1.5 cm away from the base and 1.5 cm, 5 cm, 7 cm and 9 cm away from the left side edge respectively.

d. Starting from the left side edge, we indicate with the words ALFA and BETA the starting and ending ends of the cardboard.

e. We rotate the cardboard 180 degrees and draw a vertical segment on it, distant from the left side edge 3 cm, and near this edge, to mark it as the initial end of the cardboard, considered in its behind, we write the word GAMMA.

f. The identified points are drilled: we have obtained a particular line: the multifunctional Ruler; we will use it for the creation of the Matrix for the "Structure" and the "Screen", and of the Matrix for the "Pillow".

.
.

.
.

.
.